3Installing the Antenna Units• Attach the antenna to the inner glass surface of the rear window using double-sidedtape. Carefully check the installation location as the tape can only be stuck on once.• If the surface temperature of the glass of the rear window is low, warm it by turningon the power of the rear defogger. A cold window glass surface will weaken the adhesive strength of the double-sidedtape.Also, if installation inside the cabin is performed on a day with high humidity or whenit is raining, the high humidity level will weaken the adhesive strength of the double-sided tape.• Do not install the antenna in a location where it may obstruct the field of view duringdriving, such as on the windshield.Check the location where the antenna is to beattached.Clean off any grease or dirt from theinstallation location using the supplied glasscleaner (Accessory B), clean the area with waterand allow to dry.Clean the glass thoroughly as failure toclean the glass can not only weaken theadhesive strength of the double-sidedtape, but may also cause it to come loose.Remove the protective strips from the antennaparts and the back of the antenna unit.Attach the double-sided tape of the antennaparts and the antenna unit to the rear windshieldglass. Attach the double-sided tape by firmlypressing down from the top. Secure cablesusing the supplied clampers.After attaching the antenna with the double-sided tape, allow it to sit undisturbed for 24hours. Take care not to apply force to theantenna or allow it to get wet during this time.Wire the antenna cable to TV tuner unit.54321Rear seatRear windowBundle cables with theclamper bar(Accessory C)Antenna partsAntenna unitIncar antennas have a lower reception sensitivity than antennas intended for outsidemounting. The picture may not appear or may be disturbed if the signal in your area isweak.
