在线浏览, 第3页, 建伍 Kenwood KNA-G630CN 安装说明

- 3 - Steps to Install the KNA-G630CN 1. Remove the key from the vehicle ignition and disconnect the negative battery cable. 2. Install the GPS antenna. Refer to the tips on the previous page. 3. Connect the wiring harness to your vehicle in the following order: ground, battery , ignition. 4. Connect the wiring harness to the main unit. 5. Install the main unit. Refer to the tips on the previous page. 6. Reconnect the negative battery cable. To mount the GPS antenna inside your vehicle: 1. Clean your dashboard or other surface. 2. Peel the backing of f of the adhesive on the bottom of the metal plate. 3. Press the metal plate down fi rmly on your dashboard or other mounting surface. Y o u can bend the metal plate to conform to a curved surface, if necessary . 4. Place the GPS antenna on top of the metal plate. CAUTION If your vehicle ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and of f with the ignition key . If you connect the ignition wire to a power source with a constant voltage supply , as with battery wires, the navigation system could drain your battery . W ARNING Do not connect the yellow wire directly to the vehicle battery . Connecting directly to the battery may cause the wire insulation to fail and may pose a risk of short circuit and electric shock. Optional accessory: FM traf fi c receiver SD card GPS antenna To display unit (NA V I/F terminal) Black To vehicle chassis Red To ignition (12 Vdc) Y e llow To battery (12 Vdc) Car fuse box (main fuse) Car fuse box Ignition key switch Installing the GPS Antenna Better (trunk of vehicle) Best (roof of vehicle) Good (inside car on dashboard) NOTE : The 2010 and later display unit can be connected to this system. T o check the connectable models, go to www .kenwood.com/cs/ce. 2A 2A 190-01162-02.indb 3 190-01162-02.indb 3 1/8/2010 9:39:54 AM 1/8/2010 9:39:54 AM