在线浏览, 第3页, 海能达 Hytera RD960 快速操作手册

English 2 No. Part Name No. Part Name 1 External Duplexer Jack/Rubber Stopple 4 Ethernet Port 2 GPS Antenna Port 5 Power Inlet 3 Accessory Jack 6 Antenna Connector Note: ● If the repeater is manufactured without internal duplexer, then part ① will be an external duplexer port; if it is produced with internal duplexer, then part ① will be a rubber stopple. ● When the accessory jack and Ethernet port are not in use, please cover them properly to prevent intrusion of water. 3. Status Indication LED Segment Display Indication There will be different segments shown on the LED segment display. See their indications listed below: LED Segment Repeater Status E1 Battery Mismatch E2 Low Battery E3 External Power Abnormal E4 Tx Unlock E5 Rx Unlock E6 Over Temperature LED Segment Repeater Status E7 Voltage Standing Wave Ratio (VSWR) Alarm N Current Channel Number (e.g.: 1, 2, …16) LED Indicator LED Indication Repeater Status Digital Mode Indicator Blue Working in Digital mode Analog Mode Indicator Yellow Working in Analog mode Slot A Tx Indicator Red Analog Mode: transmitting Digital Mode: Slot A is transmitting Slot A Rx Indicator Green Analog Mode: receiving Digital Mode: Slot A is receiving Slot B Tx Indicator Red Digital Mode: Slot B is transmitting Slot B Rx Indicator Green Digital Mode: Slot B is receiving Alarm Indicator Red Abnormal operation and the LED segment display gives the corresponding prompt 4. Basic Operations Powering On/Off ● Powering on/off manually a. To power on, long press the Power On/Off key (2s by