E2OVATOR S-800, S-600 & S-400 – English2 S-600 UnpackingIt is important that Ovators are unpacked as described in the following paragraphs and illustrations.They should be unpacked in the room in which they are to be used and close to their likely installed positions.Having removed this manual proceed to unpack each Ovator following the steps below:2.1 With the carton lying on its back, lift out the end-cap at the base of the speaker. The speaker has front and back castor trolleys attached to its plinth. A transit screw retains each one. Do not remove them at this stage.2.2 Using the foam insert located in the carton as a wedge, push the speaker to the end of the carton so that the trolley castors touch the cardboard.2.3 Carefully lift the carton upright using the handles on its sides. The Ovator is heavy – use an appropriate safe lifting technique.2.4 Wheel the speaker out of the carton on its trolleys, remove remaining packaging, and wheel the speaker to its likely installed position. Push the speaker from a point towards the middle or below.2.5 Remove the trolleys one at a time. Unscrew both attachment screws then tilt the speaker backwards, using your foot to stabilise it, and remove the front trolley when it is clear. Lower the speaker on to its front floor-spikes and tilt the speaker forwards to remove the rear trolley. Take care when removing the trolleys that the Ovator floor-spikes do not cause damage or injury.Note: Keep all the packing, including the transit screws and spacers. The transit screws must be replaced if the loudspeakers are to be repacked and shipped. Tighten the screws sufficiently to restrain the suspension system.2.12.22.32.42.5
