E1OVATOR S-800, S-600 & S-400 – EnglishIntroduction and UnpackingThe Ovator S-800, S-600 and S-400 are very high performance speakers that will repay effort spent on installation. It is important that you read this manual before fully unpacking and installing your Ovators. The manual begins with unpacking instructions. Ovators are extremely heavy and to minimise the risk of damage or personal injury you should follow these instructions carefully. Unpacking and installing Ovators is a two-person task and should not be attempted alone.1 S-800 UnpackingIt is important that Ovators are unpacked as described in the following paragraphs and illustrations.They should be unpacked in the room in which they are to be used and close to their likely installed positions.Having removed this manual proceed to unpack each Ovator following the steps below:1.1 With the carton standing upright, open the two front carton flaps. 1.2 Remove the inner flap to create a ramp.1.3 The speaker has front and back castor trolleys attached to its plinth that enable it to be rolled out of the carton and down the ramp. The speaker is extremely heavy – take great care. Do not work alone.1.4 Work with a another person to roll the speaker to its likely installed position. Push the speaker from a point towards the middle or below. Remove the castor trolleys one at a time. Unscrew both attachment screws then tilt the speaker backwards, using your foot to stabilise it, and remove the front trolley when it is clear. Lower the speaker on to its front floor-spikes (fitted with covers) and tilt the speaker forwards to remove the rear trolley. Even with floor-spike covers fitted, take care when removing the trolleys that the floor-spikes do not cause damage or injury.Note: Keep all the packing, including the transit screws and spacers. The transit screws must be replaced if the loudspeakers are to be repacked and shipped. Tighten the screws sufficiently to restrain the suspension system.1.11.21.31.4
