在线浏览, 第1页, 飞利浦 Philips AJ7030D/93 用户手册

Warning Never remove the casing of this apparatus. • Never lubricate any part of this apparatus. • Never place this apparatus on other electrical equipment. • Keep this apparatus away from direct sunlight, naked flames or heat. • Never look into the laser beam inside this apparatus. • Ensure that you always have easy access to the power cord, plug or • adaptor to disconnect this apparatus from the power. 2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this clock radio, you can: listen to FM radio; • enjoy audio from iPod/iPhone or an external device; • know the time; and • wake up by buzzer alarm, radio, or audio in iPod/iPhone. • What’s in the box Check and identify the contents of your package: Main unit (with a battery) • AC adapter(plug switchable) • User manual • Overview of the main unit A a PRESET Select a preset radio station. • Adjust hour and minute. • b TUNING +/- Tune to a FM radio station. • Adjust hour and minute. • c Turn on/off the clock radio. • Switch the clock radio to standby mode. • d AL1/AL2 Set alarm. • View alarm settings. • Activate/deactivate alarm timer. • e SNOOZE/BRIGHTNESS Snooze alarm. • Adjust display brightness. • f iPod/iPhone Dock for iPod/iPhone. • g VOLUME +/- Adjust volume. • h SET Store radio stations automatically/manually. • Set clock. • i SLEEP Set sleep timer. • j SOURCE Select source. • k Battery tray l AUX IN Connect an external audio device. • m AL1/2 iPhone·RADIO·BUZZ Select alarm source. • n DC 5V Power supply socket. • 3 Get started Caution Use of controls or adjustments or performance of procedures other • than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. EN 1 Important Safety Important Safety Instructions a Read these instructions. b Keep these instructions. c Heed all warnings. d Follow all instructions. e Do not use this apparatus near water. f Clean only with dry cloth. g Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. i Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. j Only use attachments/accessories specified by the manufacturer. k Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. l Unplug this apparatus during lightning storms or when unused for long periods of time. m Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. n Battery usage CAUTION – To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit: Install all batteries correctly, + and - as marked on the • unit. Do not mix batteries (old and new or carbon and • alkaline, etc.). Remove batteries when the unit is not used for a long • time. o Apparatus shall not be exposed to dripping or splashing. p Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles). q Where the plug of the Direct Plug-in Adapter is used as the disconnect device, the disconnect device shall remain readily operable. Install battery Caution Risk of explosion! Keep batteries away from heat, sunshine or fire. • Never discard batteries in fire. Danger of explosion if battery is incorrectly replaced. Replace only • with the same or equivalent type. The battery contains chemical substances, so it should be disposed • of properly. Keep children away from the battery. • Perchlorate Material - special handling may apply. See www.dtsc. • ca.gov/hazardouswaste/perchlorate. Note You can only use AC power as power supply. The pre-installed • lithium CR2032 battery can only back up time and alarm. When power is disconnected, the display backlight is off. • For first-time use: Remove the protective tab to activate the battery. To replace the battery: B Connect power C Caution Risk of product damage! Ensure that the power voltage corresponds • to the voltage printed on the back or underside of the clock radio. Risk of electric shock! When you unplug the AC adapter, always pull • the plug from the socket. Never pull the cord. Set clock 1 In standby mode, press and hold SET for two seconds to activate clock setting mode. » [12H] or [24H] is displayed. 2 Press TUNING +/- or / repeatedly to select 12/24 hour format. 3 Press SET again to confirm. The hour digits begin to blink. » 4 Repeat Steps 2 to 3 to set the hour and minute. Note If clock is not manually set, when iPod/iPhone is connected, the • clock radio synchronizes time from the iPod/iPhone automatically. Turn on Press . The clock radio switches to the last selected source. » Switch to standby mode Press to switch the clock radio to standby mode. The clock (if set) appears on the display panel. » 4 Play from iPod/iPhone You can enjoy audio from iPod/iPhone through this clock radio. Compatible iPod/iPhone The clock radio supports these iPod and iPhone models: Made for. iPod touch (1st, 2nd, 3rd, and 4th generation) • iPod classic • iPod with video • iPod nano (1st, 2nd, 3rd, 4th, 5th, and 6th generation) • iPod with color display • iPod mini • iPhone 4 • iPhone 3GS • iPhone 3G • iPhone • Listen to audio from iPod/iPhone 1 Press SOURCE repeatedly to select iPod/iPhone mode. 2 Place the iPod/iPhone in the dock. D 3 Start to play audio from the iPod/iPhone. Remove the iPod/iPhone E Pull the iPod/iPhone out of the dock. Charge the iPod/iPhone When the clock radio is connected to power, the docked iPod/iPhone starts charging. Adjust volume F 5 Listen to FM radio Tune to FM radio stations Tip Position the antenna as far as possible from TV, VCR, or other • radiation source. For better reception, fully extend and adjust the position of the • antenna. 1 Press SOURCE repeatedly to select FM tuner source. 2 Press and hold TUNING +/- for 2 seconds. The clock radio tunes to a station with strong reception » automatically. 3 Repeat steps 2 to tune to more stations. To tune to a station manually: 1 Press TUNING +/- repeatedly until you find optimal reception. Store FM radio stations automatically You can store a maximum of 20 FM radio stations. In tuner mode, press a hold SET for two seconds. The clock radio stores all the available FM radio stations » and broadcasts the first available station automatically. Store FM radio stations manually 1 Tune to an FM radio station. 2 Press SET. The preset number begins to blink. » 3 Press PRESET / repeatedly to select a number. 4 Press SET again to confirm. 5 Repeat steps 1 to 4 to store other stations. Note To remove a pre-stored station, store another station in its place. • Select a preset radio station In tuner mode, press PRESET / to select a preset number. 6 Other features Set alarm timer Set alarm In standby mode, you can set two alarms to ring at different time. Note Make sure that you have set the clock correctly. • 1 Press and hold AL1/AL2 for two seconds to activate alarm setting mode. The hour digits and alarm icon begin to blink. » 2 Press TUNING +/- or / to set the hour. 3 Press AL1/AL2 to confirm. The minute digits begin to blink. » 4 Repeat steps 2 to 3 to set the minute and alarm volume. G Select alarm source Adjust AL1/2 iPhone·RADIO·BUZZ control to select alarm source for both alarms. Note When alarm time comes, the selected radio, buzzer, or iPod/iPhone • turns on. You can only select the same alarm source for Alarm 1/ Alarm2. • If iPhone is selected as alarm source, while no iPod/iPhone is • connected, the clock radio switches to buzzer source instead. Activate/deactivate alarm timer 1 Press AL1/AL2 to view alarm settings. 2 Press AL1/AL2 again to activate or deactivate the alarm timer. » or appears if alarm timer is on and disappears if it is off. To stop the ringing alarm, press the corresponding • AL1/AL2. The alarm repeats ringing for the next day. • A C E D F G B d e k l b c a f g h m n j i Snooze alarm When alarm sounds, press SNOOZE. The alarm snoozes and repeats ringing five minutes later. » To adjust alarm interval (in minutes), press SNOOZE repeatedly. Set sleep timer This clock radio can switch to standby mode automatically after a preset period. Press SLEEP repeatedly to select the sleep timer period (in minutes). When the sleep timer is activated, » appears. To deactivate the sleep timer, press SLEEP repeatedly until [OFF] (off) appears. Play audio from an external device You can listen to audio from an external device through this clock radio. 1 Connect the audio cable to: the • AUX IN socket. the AUDIO OUT sockets of an external device. • 2 Press SOURCE repeatedly to select AUX source. » is displayed. 3 Start to play the external device (see the user manual of this device). Adjust display brightness Press BRIGHTNESS repeatedly to select different brightness levels. 7 Product information Note Product information is subject to change without prior notice. • Specifications Amplifier Rated Output Power 2 X 3 W RMS Tuner Tuning Range FM: 87.5 - 108 MHz Sensitivity - Mono, 26dB S/N Ratio FM: <22 dBf Search Selectivity FM: <28 dBf Total Harmonic Distortion FM: <2% Signal to Noise Ratio FM: >55 dB General information AC Power Model: ASSA1I-050200; Output: 5 V; 2 A Operation Power Consumption 8 W Standby Power Consumption <1 W Dimensions - Main Unit (W x H x D) 198 x 71 x 111 mm Weight - With Packing - Main Unit 0.9 kg 0.5 kg 8 Troubleshooting Warning Never remove the casing of this apparatus. • To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power Ensure that the AC power plug of the clock radio is connected • properly. Ensure that there is power at the AC outlet. • No response from the clock radio Disconnect and reconnect the AC power plug, then turn on • the clock radio again. Poor radio reception Increase the distance between the unit and your TV or VCR. • Fully extend the FM antenna. • Alarm does not work Set the clock/alarm correctly. • Clock/alarm setting erased Power has been interrupted or the power plug has been • disconnected. Reset the clock/alarm. • 9 Notice Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. This product complies with the radio interference requirements of the European Community. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/EC. Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health. 15 30 60 90 120 off © 2011 Koninklijke Philips Electronics N.V. All rights reserved. AJ7030D_93_UM_V1.0 EN User manual ZH-CN 用户手册 Register your product and get support at AJ7030D AJ7030D_93.indd 3 4/13/2011 4:43:08 PM