在线浏览, 第3页, 松下 Panasonic F-PXL45H 繁体 使用说明书

確 認 與 準 備 CONFIRMATION AND SET UP 3 灰塵感應器檢測空氣中的 PM2.5(0.3~2.5µm大小的懸浮顆粒），污染嚴重時PM2.5污染度指示燈點亮為紅色， 並通過 HEPA多功能過濾網去除PM2.5等懸浮顆粒。 配備“ PM2.5感應、提示及去除”功能 配備“智慧節能”模式 檢測到空氣潔淨時，自動停止運行，同時通過先行運行，在污染擴大前進行有效去除從而縮短運作時間節省電力。 除臭效果會根據周圍環境（溫度、濕度）、運作時間、不同種類的臭氣或纖維而有所不同。 2 3 4 此為 nanoe ® 裝置的驗證結果，它與本產品的驗證結果不同。 本產品不屬於醫療器材。 This product is not a medical equipment. Note:nanoe ® and the nanoe ® mark are trademarks of Panasonic Corporation. The deodorizer effect differs according to the surrounding environment (temperature, humidity), operation time, type of odor or fiber. This is nanoe ® device verification result, it is different from the verification of this product. Test organization: Panasonic Corporation Analysis Center 實驗機構：松下電工解析中心（株式會社） Test method: measure the allergens adhered on the fabric in a test space of 23m 3 with ELISA method 實驗方法：測定在 23m 3 實驗空間內的布塊上所附著的過敏原，採用 ELISA法進行測定 Inhibiting method: release nanoe ® 抑制方法：釋放 nanoe ® Target: pollen allergens 實驗對象：花粉過敏原 Test outcome: inhibited 88% and above after 8 hours [BAA33-130402-F01] 實驗結果：經過 8小時後，抑制88%以上的過敏原（BAA33-130402-F01） Test organization: Panasonic Corporation Analysis Center 實驗機構：松下電工解析中心（株式會社） Test method: conduct verification by using 6-phase odor intensity in a test space of 23m 3 實驗方法：在 23m 3 的實驗空間內，採用 6個等級的臭氣強度標記法進行驗證 Deodorizing method: release nanoe ® 除臭方法：釋放 nanoe ® Target: adhered cigarette odor 實驗對象：附著煙味 Test outcome: odor intensity drops to 1.2 after 2 hours [BAA33-130125-D01] 實驗結果：經過 2小時後，臭氣強度下降至1.2等級（BAA33-130125-D01） Test organization: Japan Food Research Laboratories 實驗機構：財團法人日本食品分析中心 Test method: measure the fungi adhered on the fabric in a test space of 23m 3 實驗方法：在 23m 3 實驗空間內的布塊上所附著的真菌進行確認 Sterilization method: release nanoe ® 除菌方法：釋放 nanoe ® Target: adhered fungi 實驗對象：附著真菌 Test outcome: to confirm the effect after 8 hours [Test number 13044083002-01] 實驗結果：經過 8小時後確認效果（第13044083002-01號） 注： nanoe ® 和 nanoe ® 標記為松下電器產業株式會社商標。 With function of “detecting, indicating and removing PM2.5” With “ECONAVI” mode Wall installation 掛壁安裝 The product can detect PM2.5 (0.3~2.5µm particles) in the air by dirt sensor and remove them by HEPA composite filter. The PM2.5 pollution indicator will become red when the pollution is serious. Automatically stops operating when the clean air is detected, meanwhile it also operates in advance to eliminate the dirt effectively before spreading, thus reducing the operation time and saving power. The product can be installed on the wall. Please purchase the wall-mount kit and contact the dealer for wall installation if necessary. 本產品可掛壁使用，若需掛壁安裝， 請購買 專用掛壁組件及務必聯繫經銷商進行安裝。 警告 WARNING Do not install the product by yourself. (Improper installation may not fix the unit firmly on the wall; and it may fall down, causing injury.) 不要自行安裝本產品。 (否則產品可能會安裝不牢而落下，導致受傷。)