1.2.3.4.顺时针旋转漏斗将它取出，用量勺将研磨咖啡加入金 属滤网内一杯咖啡大约需要一勺咖啡粉，具体请依照 不锈钢滤网上的刻度，然后用量勺后部将咖啡粉轻轻 抹平。 将不锈钢滤网放入金属漏斗，然后握住金属漏斗手柄 并将压钩往后拉起,按咖啡机上的标识“ ”所示， 向上放入卡位，然后通过逆时针旋转把它装入咖啡机， 直到 “LOCK”位置，见右图。将杯中的热水倒出，然后将热杯放在可移动搁板上。此时，咖啡工作指示灯是亮的，如果咖啡工作指示灯熄灭，等一会儿，一旦咖啡工作指示灯 亮起，你应该将泵开关按下, 一会儿，将会有咖啡从咖啡出口流出。注意: 在煮咖啡过程中,咖啡工作指示灯可能会熄灭(仅表示发热煲在加热,保持发热煲温度恒定在标准围内),属正常现象;制作意式浓缩咖啡为保证第一杯咖啡即可味道上乘，您需要先冲洗一下咖啡机。步骤如下：根据水尺上的刻度向水箱内加入适量的清水，不要超过最大刻度，盖上水箱盖。注意：为了方便清洁，该咖啡机配有一个可拆卸的水箱，你可以先将水箱充满水，然后再将水箱装到咖啡机上。 将不锈钢滤网装入金属漏斗（滤网内不加咖啡）将一个咖啡杯放在可移动搁板上。确保蒸汽旋钮在最小的位置。注意：该器具不配有咖啡杯，请使用你自己的咖啡杯。连接电源，将电源开关按下，则电源指示灯就会亮起。将泵开关按按下， 水泵将会泵水, 当有水从咖啡出口流出的时候关闭水泵, 确保咖啡/蒸汽选择 开关处于高位（没有按下），一会儿器具将开始预热直到咖啡工作指示灯亮起, 显示预热结束。 再次将泵开关按下，咖啡出口将会有水流出。当水不再滴之后，将所有容器中的水倒出, 然后彻底清洗它们，现在可以开始煮咖啡了。1.2.3.4.5.注意：当第一次泵水时可能会有噪音，这是正常的，器具正在释放空气，大约20S之后，噪音就会消失。初次使用之前预热为了制作美味可口的浓缩咖啡，我们建议在制作咖啡之前先预热咖啡机，包括漏斗，滤网和杯，这样咖啡的香味就不会被冷的部件影响。打开上盖，将水箱取出，装上适量的水，水位不要超过水箱中的最大标识，然后再将水箱放回 器具，再重新盖上上盖.选择一杯或两杯滤网，将不锈钢滤网放到金属漏斗上, 然后握住金属漏斗手柄并将压钩往后拉 起,按咖啡机上的标识所示，向上放入卡位，然后通过逆时针旋转把它装入咖啡机，直到 “LOCK”位置.将咖啡杯放在可移动搁板上接通电源，确保咖啡/蒸汽选择开关在“关“的位置。蒸汽旋钮处于最小位置将电源开关按下, 电源指示灯就会亮起，将泵开关按下, 当有水流出的时候，立即关闭水泵，这 个步骤的目的是水泵将水从水箱泵到机身里。当咖啡工作指示灯亮起的时候，你应该再次将泵开关按下, 将会有热水流出，当咖啡工作指示 灯熄灭的时候，关闭水泵，预热结束！1.2.3.4.5.6.29Cut off power source and let the coffee maker cool down completely before cleaning.Clean housing of coffee maker with moisture-proof sponge often and clean water tank, drip tray and removable shelf regularly then dry them. Note: Do not clean with alcohol or solvent cleanser. Never immerse the housing in water for cleaning.Detach the metal funnel through turn it clockwise, get rid of coffee residue inside, then you can clean it with cleanser, but at last you must rinse with clear water.Clean all the attachments in the water and dry thoroughly.1.2.3.4.CLEAN AND MAINTENANCETo make sure your coffee maker operating efficiently, internal piping is cleanly and the peak flavor of coffee, you should clean away the mineral deposits left every 2-3 months.Fill the tank with water and descaler to the MAX level ( the scale of water and descaler is 4:1, the detail refers to the instruction of descaler. Please use “household descaler”, you can use the citric acid (obtainable from chemist's or drug stores) instead of the descaler (the one hundred parts of water and three parts of citric acid).According to the program of pre-heating, put the metal funnel (no coffee powder in it) and carafe (jug) in place. Brewing water per “ PRE-HEATING”.Press down the ON/OFF button to the lower position , the power indicator (red) will be illuminated, you should press the pump control button to the lower position, make sure the coffee/steam button is on the higher position, when there is water flowing out and close the pump by pressing the pump control button again to the higher position, and waiting for a moment, the coffee maker begins to be heated. When the coffee ready indicator (white) is illuminated, it shows the heating is finish. Pressing down the pump control button to the lower position and make make two cups coffee (about 2Oz). Then close the pump and wait for 5s.Press down the coffee/steam button to the lower position, waiting for until the steam ready indicator is illuminated. Make steam for 2min, then turn the steam control knob to the minimum position to stop making steam. Press and release the ON/OFF to the higher position to stop the unit immediately, make the descalers deposit in the unit at least 15 minutes.Restart the unit and repeat the steps of 4-6 at least 3 times.Then pressing and release the coffee/steam button to the higher position, when the coffee ready white lamp is illuminated, press down the pump control button to the lower position to brew until no descaler is left.Then brewing coffee (no coffee powder) with tap water in the MAX level, repeat the steps of 4-6 for 3 times (it is not necessary to wait for 15 minutes in step of 6), then brewing until no water is left in the tank.Repeat the step of 9 at least 3 times to make sure the piping is cleanly.1.2.3.4.5.6.7.8.9.10.CLEANING MINERAL DEPOSITS
