4|ENGLISHRecommended Installation PositionExamples of correct camera installation on the rear of the vehicleInstallation positionMount so that the “KENWOOD” logo appears at the top.Installing the Camera/Adjusting its angle1 Decide the camera installation position.2 Clean the camera installation surface.Using a commercially available cleaner, wipe dirt, moisture and oil away from the surface on which the camera bracket is to be attached.3 Loosen the camera bracket retaining screws.Using a commercially available Phillips screwdriver, loosen the two retaining screws.Perform steps 4 and 5 only when they are required.4 If required, separate the camera bracket from the camera and adjust the shape according to the surface on which it will be attached.BendBendCamera bracket (A)Adjust the camera bracket shape so that it fi ts the camera installation position.5 Mount the camera on the camera bracket.Mount so that the “KENWOOD” logo appears at the top.6 Fix the camera temporarily with tape, etc.Using a piece of tape, etc., fi x the camera temporarily.12345Install the camera at the center of the vehicle and not to hide the number plate. And also install straight toward the forward/reverse direction of the vehicle. Be careful not to lean the camera toward other directions of the vehicle, etc.7 Complete all of the required connections.8 Display the camera video.Before viewing the camera, apply the parking brake and chock the wheels so that the vehicle will not move. Otherwise, an unexpected accident may result.For displaying the camera video, read the instruction manual for your video monitor.Change the shift lever to the R (Reverse) range to view the image of the rear of the vehicle.9 Adjust the camera angle.When adjusting the camera angle, be careful not to stretch the camera cord.Adjust the angle so that the rear of the vehicle or the bumper can be seen at the bottom of the monitor.Vehicle rear part or bumperInstallationCMOS-230.indb 4CMOS-230.indb 414/11/07 13:1714/11/07 13:17
