4|DDX5032/DDX5032MConnectionBCPRK SW–+BCAAIf you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box.Antenna CordFor the sake of safety, be sure to connect the parking sensor. Parking sensor wire (Light Green)Connect to the vehicle's parking brake detection switch harness.Battery wire (Yellow)Ground wire (Black) - (To car chassis)Ignition wire (Red)Steering remote control input (Light Blue/Yellow) To steering remoteIf no connections are made, do not let the cable come out from the tab.Connect to the terminal that is grounded when either the telephone rings or during conversation.Mute wire (Brown)Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna.Motor antenna control wire (Blue)When using the optional power amplifier, connect to its power control terminal.Power control wire (Blue/White)To car light control switchDimmer control wire (Orange/White)Reveres sensor wire (Purple/White)Connect to vehicle's reverse lamp harness when using the optional rear view camera. Ignition key switchACCCar fuse box (Main fuse)BatteryCar fuse boxTo connect the Kenwood navigation system, consult your navigation manual.To use the steering wheel remote control feature, you need to an exclusive remote adapter (not supplied) matches your car is required.When this terminal is not in use, leave its cap on. B54-4620-00_00_en.indd 4B54-4620-00_00_en.indd 407.12.18 2:26:30 PM07.12.18 2:26:30 PM
