在线浏览, 第4页, JVC CU-VD40AA 使用说明书

4 This burner enables DVDs of videos recorded with the JVC Hard Disk Camera to be created without using a PC. ● If you want to edit videos recorded with the camera and create your original DVDs, use the software provided with the camera for editing and creating DVDs. ● The provided data writing software Power2Go 5.5 Lite can be used for writing data. However, it cannot be used to edit videos or create DVDs. ● The burner does not include support for Macintosh. Dear Customer, Thank you for purchasing this burner. Before use, please read the safety information and precautions contained in pages 4 and 5 to ensure safe use of this product. Safety Precautions IMPORTANT: In the event that any of the following occur, remove the plug and make a request for repair to the dealer. ● Smoke or abnormal odour is emitted ● Damage from being dropped ● Water or an object enters inside CAUTION: A UNIT IS A CLASS 1 LASER PRODUCT. HOWEVER THIS UNIT USES A VISIBLE LASER BEAM WHICH COULD CAUSE HAZARDOUS RADIATION EXPOSURE IF DIRECTED. BE SURE TO OPERATE THE UNIT CORRECTLY AS INSTRUCTED. WHEN THIS UNIT IS PLUGGED INTO THE WALL OUTLET, DO NOT PLACE YOUR EYES CLOSE TO THE OPENING OF THE DISC TRAY AND OTHER OPENINGS TO LOOK INTO THE INSIDE OF THIS UNIT. USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL. CLASS 1 LASER PRODUCT REPRODUCTION OF LABELS WARNING LABEL INSIDE OF THE UNIT This unit applies to the standard “IEC60825-1:2001” for laser products. The socket-outlet shall be installed near the equipment and shall be easily accessible. ATTENTION: This unit contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the unit off and unplug the mains power cord. Then plug it in again and turn the unit on. Take out the disc. After checking the disc, operate the unit as usual. CAUTION: To avoid electric shock or damage to the unit, first firmly insert the small end of the power cord into the AC Adapter until it is no longer wobbly, and then plug the larger end of the power cord into an AC outlet. If malfunctioning occurs, stop using the unit immediately and consult your local JVC dealer. ● FOR USE WITH MODEL NO. AP-V400U (AC ADAPTER). • 043-124000-I2 (AC Adapter) is also available for customer using CU-VD40AC/AG. Caution on Replaceable lithium battery The battery used in this device may present a fire or chemical burn hazard if mistreated. Do not recharge, disassemble, heat above 100% or incinerate. Replace battery with Panasonic (Matsushita Electric), Sanyo, Sony or Maxell CR2025. Danger of explosion or Risk of fire if the battery is incorrectly replaced. ● Dispose of used battery promptly. ● Keep away from children. ● Do not disassemble and do not dispose of in fire. WARNING: Batteries shall not be exposed to excessive heat such as direct sunshine, fire or the like. The C/B button does not completely shut off mains power from the unit, but switches operating current on and off. ABB shows electrical power standby and ACB shows ON. CU-VD40A_009_EN.book Page 4 Thursday, April 19, 2007 4:52 PM