8 | EN GLISHEN G LISH |9Set the current date by rotating the crown counter-clockwise.SET THE DATE/SECURE THE CROWNPull the crown into position 1.Push the crown back to the initial position.WARNINGDo not use the quick set function for the date between 8:00 p.m. and 2:00 a.m. because there is no assurance that the date will change at midnight after that; it may not change for another 24 hours.To stop measuring time, press the P1 pusher again and read where it stopped.Use the P2 pusher to reset all the counters to zero.MEASURE TIME (CHRONOGRAPH)Start measuring time using the P1 pusher. The seconds counter is in motion.The chronograph can be used to measure time intervals for up to 1 hour exactly to 1/ 8 sec-ond. The time measured can be read using the seconds and minutes counters.CLEANINGTo clean the outer surface of the watch, wipe it gently with a microfiber cloth. Use a fine toothbrush and a bit of soapy solution to clean the back of the watch and the metal band. Dry using a lint-free towel. Minimize contact between the leather straps and the water. MAINTENANCEAs a mechanical instrument, a watch requires maintenance by an authorized service center about once every four years.CLEANING AND MAINTENANCEA watch tested to 3 atm (30 m) is resistant to sweat, drops of water and rain. Water resis-tance is guaranteed only if the crown is in the initial position and should be checked once per year.WATER RESISTANCE30 m | 3 atm50 m | 5 atm100 m | 10 atm200 m | 20 atm300 m | 30 atmTHE BINDING NATURE OF METER DATADo not swim/diveBath, shower, swimSwim, snorkelSwim, snorkel, diveDeep-sea diving213123
