4Assembling the TurntableThe AT-LP60-BT requires some assembly before first use. IMPORTANT: Do not connect the AC power cable until assembly is complete.1. Carefully place the turntable platter on the center spindle, making certain the platter is fully seated on the spindle.2. While holding both ends of the red tape ribbon on the turntable belt, carefully pull the belt over the brass motor pulley (Fig. 2a). (If the belt drops off, remove the turntable platter and put the belt back on it, as described on page 7.)3. Once the belt is seated in the pulley’s groove, carefully remove the ribbon. Make certain the belt is not twisted. (NOTE: If the belt is not correctly positioned around the motor pulley, the turntable will not operate. Please double-check to make sure that the belt is positioned correctly.)4 Place the turntable mat on top of the turntable platter (Fig. 2b).5. If desired, the hinged dust cover may be removed. Hold both sides of the dust cover and pull upward gently and evenly to detach the cover from the turntable (Fig. 2c). Keep the cover in a safe, clean place. 6. To re-install the dust cover, guide the dust cover hinges into the two hinge receptacles located at the back of the turntable housing.Setting the Pre-amplifier Selector Switch (PHONO/LINE)For increased flexibility of use, this turntable has an internal stereo phono pre-amplifier. The pre-amplifier selector switch (PHONO/LINE) switch is located on the back of the turntable. If the stereo system you are using has a PHONO input, set the pre-amplifier selector switch to the “PHONO” position. If your stereo system does not have a PHONO input, set the pre-amplifier selector switch to the “LINE” position and connect the turntable’s output cables to the AUX or other high-level input on your stereo system (described later) (Fig. 3).The pre-amplifier selector switch does not affect wireless connection. You can leave the switch in either position when connecting the turntable to a Bluetooth receiver device.PHONOLINEPHONOAUXInput jacksPre-amplifier selector switchStereo systemWhite RedACACFigure 32b – Record mat2c – Dust cover removalFigure 2 – Assembling the turntable2a – Drive beltRed ribbonBrass motor pulleyDrive belt45-RPM adapterBrass motor pulleyInitial Setup
