在线浏览, 第4页, 马歇尔 Marshall CODE50 用户手册

FRONT PANEL FUNCTIONS 1 2 3 4 5 6 15 16 17 18 19 20 2. INPUT Use this jack socket to connect your guitar to the amplifier. Use a good quality screened/shielded guitar cable to help prevent noise interference. 3. GAIN Controls the amount of Gain introduced to a Preset. The higher the Gain, the harder the preamp is driven. 4. BASS Turning the BASS control will adjust the warmth and low-end depth of your sound. 5. MIDDLE Adjusting the MIDDLE control will vary the amount of body in your sound by boosting or cutting midrange frequencies. 6. TREBLE Increasing the TREBLE will make your sound brighter and more cutting. Turning the TREBLE down will decrease tonal edge and make the sound softer. 7. VOLUME Controls the volume level within a selected Preset. Because GAIN, BASS, MIDDLE, TREBLE & VOLUME are stored as part of a Preset, these panel tone controls only become active when they are used. This means that until they are turned their position is not related to their setting within a Preset. When you turn a tone control it becomes active. The display screen will show its current setting and the stored setting. When a GAIN, BASS, MIDDLE, TREBLE or VOLUME control is activated the EXIT/STORE LED will flash red to show that the Preset’s stored settings have changed. 7 8 10 13 14 12 21 23 22 11 1. USB Connect via USB to use CODE as a DAW interface, to play tracks from your music library, to get firmware updates and control via MIDI.. ENGLISH ENGLISH ! ! 9 To record with CODE using your DAW: • Connect to your computer via USB. • Select your CODE amplifier as the input source on your computer and within your DAW. To stream audio from your computer through CODE: • Connect to your computer via USB. • Select your CODE amplifier as your computer’s output source. • Use the MASTER control to adjust the volume level (#8 in this manual). To get CODE firmware updates: http://my.marshall.com/Downloads Follow this link to quickly and easily keep your CODE amplifier’s firmware up to date. MIDI data: • Your CODE amplifier can also send and receive MIDI data related to the front panel controls via the USB.